       
|
|
We have a range of
milling tools that are designed for quick removal of any
coatings, such as epoxy and glue from concrete floors. The
heavier duty Barracuda is also well
suited to efficiently flatten bumpy concrete surfaces! |
|
 |
The DCT Combo Coatings tool works by riding on the diamond segment
which limits travel of the tool into the concrete surface. Perfect for
lighter machines below 500 lbs. This allows
the two 1/4 heads to scrap away coatings or Glue, but not damage the concrete
itself. The trailing segment itself will also cut through thin mil coatings that the PCD
scrappers miss, helping remove coatings. This tool is very aggressive and will work on lighter machines.
only $29.00 each
|
Barracuda
The Barracuda is well suited to Floor Machines that are over 500 Lbs, and where less scratching is desired.
Designed to quickly remove adhesive glues and hard epoxy coatings, as
well as flaking or bumpy concrete surfaces.
only $59.00 each
|
 |
 |
The Barracuda tool works by riding on the tail disk
which limits travel of the tool into the concrete surface. This allows
the head to scrap away coatings or Glue, but not damage the concrete
itself. The tail itself will in time develop a sharp edge that will also
help remove coatings. If removal of the concrete surface is wanted then
use of the Barracuda Light will allow more removal of the concrete
itself. |
Metal Diamond Tools
To grind floors effectively it is necessary to use metal tools to grind down through the cap and leave a substrate that is ready to coat, seal or polish. Click on the picture to see the metal diamond tooling.
Made in the USA! No Duty into Canada or Mexico
Click on picture for more info > |
 |
Resin Diamond Tools
To bring a floor up to a high shine it is necessary to use
Resin tools to polish the substrate to the look you seek or to coat,
seal or polish. Click on the picture to see the Resin diamond tooling.
Click on picture for more info > |
 |
| |
|
Contact
Levetec
